• For Generac QT070 70kW generators and up.

• For all Caterpillar Generators on our site.

HTS Transfer Switch
The HTS transfer switch is a "smart switch" designed to operate in conjunction with the PowerManager® H-100 controller. HTS switches have a 2-wire RS485 communication link to the controller. Utility voltage and phasing are monitored by the HTS switch along with signal before transfer timing, time delay neutral and in-phase transfer. All timers and voltage set points are remotely programmable via GenLink®  communications software.

External LED displays on the outside of the door show the switch position, indicate when the generator is operating and whether or not the utility is available. An external, 3-position test switch allows testing in either normal or fast mode without opening the cabinet. HTS transfer switches are available in 100 to 2600 amp models with a choice of NEMA 1, NEMA 3R or NEMA 12 enclosures and are rated to all classes of loads.
HTS 100-400 Amps Spec Sheet            

HTS 600-1000 Amps Spec Sheet            

HTS 1200-2600 Amps Spec Sheet