Product Features
Standard Model
-
Used on engines with one spark firing on each revolution of the crankshaft.
-
1 cylinder 2 stroke (reads 1x / revolution) Generac, Briggs, Kohler and Honda type engines - (Air-Cooled generators only).
-
4 stroke with electronic ignition and no points.
-
2C can also be used on 2 cylinder engines where the cylinders fire 1X per revolution.
Note 1: Engines frequently referred to as a "4 stroke" may not be a true 4-stroke because they fire on the exhaust stroke as well – requiring a 2C.
Note 2: You cannot reset, hours will accumulate.
Standard Tiny-Tach™ — Installation Instructions
The Tiny-Tach™ meter can be mounted in the desired location using either sheet metal screws
or by using double sided tape. For best results when using tape, be sure to clean off any dirt,
grease and oil from the desired mounting location using a suitable solvent such as denatured
alcohol. Find a suitable route to run the pick-up wire to the spark plug wire.
It is not critical how the wire is routed. It can be put into existing wire harnesses or wrapped
around and taped to metal supports. Caution: Keep wire clear of extremely hot engine parts such
as the muffler, etc. Wire damage (cuts or burns) will cause the wire to short and your
Tiny-Tach™ will stop working. Wire damage is not under warranty. The red
wire should be wrapped around section of the spark plug wire using 3-4 turns. Please be certain
you do not wrap the red wire too close to the spark plug that engine vibration will allow it to come into direct contact with the metal portion of the spark plug. Most engines have a spark plug cap and will prevent this from happening. After the connections are made, any excess wire can be coiled up and taped to a convenient area.
|
